High efficiency low pressure DTH hammer CIR 90
SPECIFICATION
Product type: DTH hammer (down-the-hole hammer)
Series: Superdrill
Working pressure: High pressure (7 to 30 bar)
Quality control: Hydrostatic and function test before shipment, spare parts matched to the shank design
Customization: OEM marking, custom packing and matched bit supply available
DETAILS
This Superdrill range covers multiple hammer sizes with a matched shank design, so one supplier can cover a complete drilling programme from small anchor holes to large diameter water wells.
Superdrill DTH hammers use a simple structure that is easy to assemble and disassemble, with reliable quality and a long service life. Hammer models cover hole diameters from 64 mm to 1000 mm (2-1/2 inch to 39-3/8 inch) in low, middle and high pressure versions.
Air consumption rises with working pressure, so the compressor must be sized for the highest pressure the hammer will run at. Running below the recommended pressure reduces impact energy and slows penetration, while running far above it shortens piston and bit life. Check the air consumption figures in the table against the compressor output at the actual working altitude before choosing a model.
| DTH hammer type | CIR76 | CIR90 | CIR110 | CIR130 | CIR150 |
| Bit Shank: | CIR76 | CIR90 | CIR110 | CIR110/CIR130 | CIR150 |
| Top Sub Thread: | F48x10PIN | F48x10PIN | API 23/8" RGE BOX | API 23/8" RGE BOX | F70x10PIN |
| Bit Diameter: | 76(mm) | 90-120(mm) | 110-150(mm) | 130-175(mm) | 150-200(mm) |
| Working Pressure: | 4-10(bar) | 5-10(bar) | 5-10(bar) | 5-10(bar) | 5-10(bar) |
APPLICATION
Quarry and open pit blast hole drilling, mining production drilling, water well and geothermal drilling, foundation and anchor piling, construction and road building, and general down-the-hole drilling where a Superdrill shank hammer is used.
HOW TO ORDER
Please confirm the hammer model or hole diameter, the shank type, backhead thread, compressor output and working pressure, plus the quantity of hammers and matched bits. Tell us the rock type and hole depth so we can recommend the right model, and we will quote hammers, bits, adapters and spare parts together.
ADVANTAGES
• Simple valveless air cycle with few wearing parts
• Matched shank and backhead thread for direct replacement
• Hardened piston and cylinder for long service life
• Stable impact energy at the recommended working pressure
• Bits, adapters and spare parts supplied from the same source
• OEM marking and custom packing available on request